Congratulations! Now Your Going to install World Best Scratch Protection!​ .

PREPARING TO INSTALL

1. Please read all the given instructions before start to install
2. Installation instructions and installation kit will be provided along with this pack!
3. Make sure your hand is clean before starting the installation
4. Clean the device with the cloth, which removes any dirt’s
5. Switch off the mobile

Installation

Before removing the skin wet all your fingers with the solution and start from a corner, remove slowly and carefully without stretching it.

Tip: Always Keep your fingers wet to avoid fingerprints and begin with the larger pieces first.

Remove the skin spray the solution, and apply the skin with the adhesive side facing down, carefully align the top, bottom, and sides of the Gadgets protector to the area of your device. Be sure to note that cut outs for buttons and speakers are centered and aligned. If it is not aligned perfectly, quickly lift the skin up and try again.

If you are not okay with the alignment of a particular piece, remove it slowly and wet it in solution and stick it again until you satisfied with the alignment

Use the lint-free cloth and the card to remove the excess solution and bubbles under the skin away from the center and towards the edges

Wait for 5-10 minutes and start squeezing again with card. Use the cloth and absorb all the excess solution. Start pressing down all the side flaps with enough pressure so that they stick down on the device

PERFECTION: Once all the portions are installed, keep your device SWITCHED OFF for 4-5 hrs to let the skin set and all the left over moisture to dry out. After 4-5 hrs, the skin will dry out and you can start using your device

IMPORTANT: After the installation, you may see small-bubbles streaks, and imperfections. Your screen and the device might look fuzzy. Don’t be tensed After 2 to 3 days it will automatically disappear.

Installation Video

Installation Video

Close Menu
×
×

Cart